##plugins.themes.huaf_theme.article.main##
Tóm tắt
Nowadays, renewable energy such as wind and solar energy can be employed for marine application to enhance clean and green technology. So, using battery is necessary to apply power for ship activities. To contribute sustainable development, optimizing structure in electric transmission such as bimetal connector Cu-Al is necessary to improve joint quality. This study focused the influence of welding parameters on the quality of the lap-joint between AA6061 aluminum alloy and C1100 copper. Experimental results indicate that the welding interface was sensitive to welding speed. Some welding defect was found in the joint such as tunnel and hook defects. The highest tensile strength produced by the welding speed of 200 mm/min was approximately 1100 N. In all experimental regimes, the weld zone structure, hardness distribution, tensile strength, fracture location, and local deformation were analyzed and discussed in detail.
Keywords: Friction stir welding, microstructure, mechanical properties, hardness